BETTERSTAINEDGLASS.COM
Phone (801)
344-0178 • Fax (510) 892-4564
March 2007 How To Aggressively Reinforce A Window
|
|
||||
|
BETTERSTAINEDGLASS.COM |
|
|||
|
Really,
I'm surprised, but we had a chance to
catch our breath during January and February.
We've had plenty of jobs to keep us busy,
but not to the punishing extent that we
had in November and December.
We are in the middle of building windows for an entryway which can only go into a home with 12 foot high ceilings, we are designing windows for a local art center and we are working out details for a false skylight and transoms for a parade of homes entrant. Yea, there's always plenty to do! |
|
|
|
|
| Last month, we showed how to add strength to a window by adding zinc outer bar. But with large panels, we need to add additional support. Often we can run many copper strips through the lines of the window (see the Aug 2006 newsletter) But what to do when the design doesn't allow enough lines to adequately strengthen the window? | |
|
How To Aggressively Reinforce A Window |
|
| We try to encourage designs that are not only beautiful, but practical as well. Occasionally a client wants something that challenges us and we need to add additional reinforcing to strengthen the window. | |
|
|
This window only had 3 lines which continued across the panel from one side to the other. So I determined that I would have to build it with two pieces of copper stripping instead of just one. |
|
|
It was difficult to get two pieces of copper between the glass. You can see in this photo that there are two strips going in each direction. |
|
|
You can see that this design is very simple. You can also see that if we were to put reinforcing across the lines that don't extend across the panel they would create stress points where the glass might tend to break. |
|
|
Here at the edge you can see both pieces of copper. When I solder these pieces, the copper strips cause the solder to wick down into the channel. So with the strips in place, the lead line is stronger because the copper resists bending back and forth and the additional solder provides additional anchoring to the other strip and the copper foil that surrounds the glass. |
|
|
I can now turn the panel over by following the directions on handling glass that I spelled out in our September 2005 newsletter. |
|
|
|
| Here the panel is complete and ready for installation. I gave the client a board that was the same size as the glass, so that the panel would have additional support as it was shipped home. Once the window was installed, it was much stronger since it is supported all the way around. I still worry that the design is very weak, but I feel better knowing that I've added as much extra support as possible. | |
|
|
|
| And here it is installed. Now that it's in place and well supported, there's nothing to worry about. The glass is secure in the framework and is reinforced so that the pressure of cleaning the glass won't do damage to it. | |
|
Email: david@gommstudios.com |
|
|
Send us e-mail with your comments and suggestions. We enjoy the chance to share with others. |
